You are not logged in.
Pages: 1
I ran this (my wifi chipset is Broadcom, anyway) :
ifconfig wlan0 up
And the output was:
SIOCSIFFLAGS: No such file or directory
So I followed the guide on this page, and stuck at this part:
FATAL: Module wl not found
Any idea?
Offline
Did you download the broadcom driver module from http://aur.archlinux.org/packages.php?ID=19514 ?
Perhaps this could help with that process: https://wiki.archlinux.org/index.php/AUR
Last edited by 3]) (2010-11-25 22:32:01)
“There are two ways of constructing a software design. One way is to make it so simple that there are obviously no deficiencies. And the other way is to make it so complicated that there are no obvious deficiencies.”-- C.A.R. Hoare
Offline
You should try b43 (in-kernel driver) first, before going for wl.
If you want more detailed assistance, provide more details.
Offline
i just reread the tutorial again, and i finally found the mistake:
i only run makepkg, and then modprobe wl after that
i forgot to install the newly built broadcom-wl package >_<
Offline
Pages: 1