You are not logged in.
Pages: 1
Since I am in a constant learning mode with Arch I wanted to do an utter format and reinstall it on the stand alone computer I have. This is the one where I installed arch once before ( and it was working ok ). Going through the installer, I partitioned the hard drive as follows:
disc1 = bootable 1015 MB Primary Root
disc5=780 MB Logical Swap
disc6 =5015 MB Logical usr
disc7 = 7005 MB Logical Var
disc8= 19000 Mb Logical home
All were using ext 3 except swap of course. The part that annoys me is that when it came time to set the mount points ( which is the last column in my small list above), the screen shows a disc2 in the list. What is disc2 and where is it from????? The thing is that I had figured it out before, but I just have no clue at this point.
This is a straightforward ( I thought ) format and install of Arch ( much like you can do with Windows....which may be my first mistake )
Thanks,
BobL
Offline
Ah,
Thank you! The moment I read your reply the answer was obvious! Then again, I should not have done this when I was tired. *sigh*
Anyway I can now proceed.
Thanks again!
BobL
Offline
Pages: 1