You are not logged in.
hey guys,
as the topic says I habe a syntax error in /etc/conf.d/splash. On boot I get the following message:
/intit: /etc/conf.d/splash: line 33: syntax error: unexpected "(" (expecting ")")
tried to find out what it is but I'm stuck now. Here is the file:
#
# /etc/conf.d/splash
#
#### initcpio and Fbsplash daemon ##########################################
## Themes to include into initcpio
## For a smaller initcpio you may try theme cfg files instead of directories.
SPLASH_THEMES="
arch-black-spin
"
## Override the initial silent splash screen status message defaults.
## Note: '$progress' will be replaced by Fbsplash itself.
## * initcpio - (no effect with fbcondecor kernel)
SPLASH_INIT_MESSAGE="Initializing the kernel"
## * bootup
SPLASH_BOOT_MESSAGE="Booting '$HOSTNAME' (\$progress%)"
## * reboot
SPLASH_REBOOT_MESSAGE="Rebooting '$HOSTNAME' (\$progress%)"
## * shutdown
SPLASH_SHUTDOWN_MESSAGE="Shutting down '$HOSTNAME' (\$progress%)"
## To show animations early, include the Fbsplash daemon (1.5 MiB) into initcpio, too,
## instead of the small helper only.
## Note: Themes with 'scripts/rc_init-pre' like 'arch-banner-icons' are not supported.
SPLASH_DAEMON="early"
## Make the splash daemon use fade effects.
## Note: The initcpio helper does only use the kernel parameter!
SPLASH_EFFECTS="fadein,fadeout"
## Uggly hack to get that in from the kernel line :p
#SPLASH_EFFECTS=$(e=();IFS=',';for w in $splash;do [[ $w == fade* ]]&&e+=($w);done;echo "${e[*]}")
## Enable the textbox when starting the Fbsplash daemon.
## Useful if the theme provides a message log or other textbox.
## The scripts write any initscripts [FAIL] messages to the log.
## Note: The textbox can also be toggled by pressing F3-key.
SPLASH_TEXTBOX="yes"
## Splash progress timeout
## If set to a positive value, Fbsplash will automatically switch to verbose
## mode if there is no progress for the specified number of seconds.
SPLASH_AUTOVERBOSE=0
#### scripts behaviour #####################################################
## Change to verbose mode on any initscripts [FAIL] message
## Useful with very simple themes and also when starting Xorg from DAEMONS
SPLASH_VERBOSE_ON_ERRORS="yes"
## Name of the DAEMONS script starting Xorg if any
## Set this to avoid virtual terminal change struggle between Xorg and Fbsplash.
#SPLASH_XSERVICE="gdm"
#SPLASH_XSERVICE="kdm"
#SPLASH_XSERVICE="xdm"
#SPLASH_XSERVICE="lxdm"
#SPLASH_XSERVICE="slim"
## Push initscripts [BUSY] messages to the splash status message line.
SPLASH_PUSH_MESSAGES="no"
# EOF #
Last edited by theguzz (2011-04-14 19:29:21)
Offline
I should mention that I also deleted the line
#SPLASH_EFFECTS=$(e=();IFS=',';for w in $splash;do [[ $w == fade* ]]&&e+=($w);done;echo "${e[*]}")
since i don't really need it.
After a rebeoot the error still persists...
What is my fault?
Offline
well... got it!
mkinitcpio -p kernel26
does the magic!
Offline