You are not logged in.
Hi,
I installed arch with 3 harddrives, one for the system, the other for a raid 1, the system and the raid are encrypted. Installation worked without any problems. I typed "reboot", changed the boot sequence in the bios, tried the keyboard within grub, no problem yet. Then arch booted and when I should enter my password, my keyboard just stopped working. I tried to enable the numpad to see the small light, no signal. I booted again, enabled the numpad, light is working, booted arch and the light stopped. Did I miss to load usb module during installation or something else? The keyboard worked fine during installation of course.
Thanks for any further help or advice.
Regards
Last edited by orcane (2011-04-15 23:27:41)
Offline
Did you remember to include usbinput in the HOOKS array in your /etc/mkinitcpio.conf
Offline
Well to be honest, I think i forgot this. Thanks for the hint.
Is there an easy way to edit the file after the installation?
There is another interessting line which says: md0: detected capacity change from 0 to .... and then the raid tries to resync, but why? Thanks.
Offline
Offline
Thanks
Offline