You are not logged in.
have you checked your bios settings?
Yes, it's enabled by bios!
Offline
Same problem here with a 8191SE. AUR driver used to work on 2.6.36. I've switched to 2.6.38 and recompiled rtl8192se 2.6.0019.1207.2010-4 and
rtl8192se-firmware 2.6.0019.1207.2010-1.
However when I turn the radio on I see the following error message:
GPIOChangeRF - HW Radio ON, RF ON
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:request firmware fail!
rtl819xSE:Firmware Download Fail!!a
rtl819xSE:ERR!!! NicIFEnableNIC(): initialization is failed!In /lib/firmware/rtlwifi I have:
- rtl8192cfw.bin
- rtl8192cufw.bin
- rtl8192defw.bin
- rtl8192sefw.bin
- rtl8712u.bin
Offline
I installed the two rtl8192se AUR packages a second time and manually ran a depmod -a. Now everything is fine.
Offline
I really don't know how I could achieve this but I finally managed to turn on the wireless card and get it working. I found out that every time I booted, the wireless card was recognized only if I didn't press "Fn+F2" during the boot (otherwise the driver wasn't loaded) and running "ifconfig wlan0 up" turns it on. So I added this command to my /etc/rc.local and now everything is fine. I'd really appreciate if someone could explain me what's happened!!!
Last edited by schizzz8 (2011-04-18 06:55:35)
Offline