You are not logged in.
Pages: 1
Hi,
I am using Arch with kernel 2.6.38 on a Thinkpad T23 laptop. both udev and pcmciautils are installed. my Ali card is detected:
output from lspci:
07:00.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03)
07:00.1 USB Controller: ALi Corporation USB 1.1 Controller (rev 03)
07:00.3 USB Controller: ALi Corporation USB 2.0 Controller (rev 01)
07:00.4 FireWire (IEEE 1394): ALi Corporation Device 5213
lspcmcia shows:
Socket 0 Bridge: [yenta_cardbus] (bus ID: 0000:02:00.0)
Socket 1 Bridge: [yenta_cardbus] (bus ID: 0000:02:00.1)
lsmod | grep pcmcia returns:
pcmcia 30510 0
pcmcia_rsrc 8616 1 yenta_socket
pcmcia_core 9762 3 pcmcia,yenta_socket,pcmcia_rsrce]
everything seems to be OK, except that when I connect my usb stick or scanner to the card, no device shows up! it just shouldn't be this much difficult and time consuming to setup and use a pcmcia card!
Offline
Pages: 1