Arch Linux

Lockheed

Member

Registered: 2010-03-16

Posts: 1,542

Help - undervolting broke clocking-down

I was trying to follow this guide
https://wiki.archlinux.org/index.php/PHC
but of course PHC Tool doesn't work on Arch because of too new Python version and automatic finding of lowest stable voltages didn't work either (it only found stock).
So I abandoned it but now mu C2D won't even downclock and runs at 2100MHz at all times.

ngoonee

Forum Fellow

From: Between Thailand and Singapore

Registered: 2009-03-17

Posts: 7,358

Re: Help - undervolting broke clocking-down

Reverse the changes you made.

---

Allan-Volunteer on the (topic being discussed) mailn lists. You never get the people who matters attention on the forums.
jasonwryan-Installing Arch is a measure of your literacy. Maintaining Arch is a measure of your diligence. Contributing to Arch is a measure of your competence.
Griemak-Bleeding edge, not bleeding flat. Edge denotes falls will occur from time to time. Bring your own parachute.