Arch Linux

nticompass

Member

From: /home/nticompass/

Registered: 2009-12-08

Posts: 55

Website

iwl4965 can't see Wireless n networks

After updating, I suddenly can't connect to wireless n networks.  I can connect to my g network just fine.

I am using the iwl4965 driver and firmware 228.61.2.24.

dmesg | grep -i iwl          
[    9.746844] iwl4965: Intel(R) Wireless WiFi 4965 driver for Linux, in-tree:
[    9.746848] iwl4965: Copyright(c) 2003-2011 Intel Corporation
[    9.746964] iwl4965 0000:05:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
[    9.746998] iwl4965 0000:05:00.0: setting latency timer to 64
[    9.747054] iwl4965 0000:05:00.0: Detected Intel(R) Wireless WiFi Link 4965AGN, REV=0x4
[    9.790501] iwl4965 0000:05:00.0: device EEPROM VER=0x36, CALIB=0x5
[    9.790523] iwl4965 0000:05:00.0: Tunable channels: 11 802.11bg, 13 802.11a channels
[    9.790695] iwl4965 0000:05:00.0: irq 44 for MSI/MSI-X
[   10.076180] iwl4965 0000:05:00.0: loaded firmware version 228.61.2.24
[   10.224787] ieee80211 phy0: Selected rate control algorithm 'iwl-4965-rs'
[  167.487418] iwl4965 0000:05:00.0: Aggregation not enabled for tid 0 because load = 1

EDIT:

After rebooting ~5 times, it worked...

Last edited by nticompass (2011-06-27 01:11:33)

oliver

Member

Registered: 2007-12-12

Posts: 448

Re: iwl4965 can't see Wireless n networks

After rebooting ~5 times, it worked...

interesting... but what prompted you to reboot a 5th time if 4 had failed?

nticompass

Member

From: /home/nticompass/

Registered: 2009-12-08

Posts: 55

Website

Re: iwl4965 can't see Wireless n networks

After rebooting ~5 times, it worked...

interesting... but what prompted you to reboot a 5th time if 4 had failed?

Insanity: doing the same thing over and over again and expecting different results.
- Albert Einstein