You are not logged in.
I have 8 drives in my system on 2 controllers. The bios prefers them on one controller first, followed by the other. I understood Linux didn't care about this. I want to use the first drive on the second controller as my boot drive. When I installed, this drive was listed as sda. After a couple of reboots, it became sde. Now it's back to sda. It doesn't matter to the system as I am using labels, except for swap. When the drives change, it doesn't activate because fstab is looking for the wrong drive. What's the solution for this?
Last edited by timm (2011-07-21 18:25:40)
Offline
https://wiki.archlinux.org/index.php/Pe … ice_naming says you can use a label for swap too.
Last edited by karol (2011-07-21 18:24:43)
Offline
Missed that, thanks.
Offline