You are not logged in.
Pages: 1
Hi everyone,
I've tried installing my epson ME 330 this morning using the CUPS page on the wiki.
So I've installed cups, ghostscript & gsfonts as well as gutenprint (and after that, all the other drivers, as I was starting to get a little desperate )
The problem is, when I go to cups' web interface, my printer cannot be found...
I've blacklisted usblp and dmesg gives me
usb 1-1.4: new high speed USB device number 5 using ehci_hcd
I feel like there should be a "configuration #1 chosen from 1 choice" line ... but there isn't :S
when I do not blasklist usblp though, I get :
[ 1748.458150] usb 2-1.2: new full speed USB device number 11 using ehci_hcd
[ 1748.547359] usblp0: USB Bidirectional printer dev 11 if 1 alt 0 proto 2 vid 0x04B8 pid 0x085C
no usb.c / printer.c messages are next ...
I've also tried installing epson-inkjet-printer-escpr from AUR ... which changed nothing
so ... if anyone has an idea ...
thank you
Offline
Kernel 3.0 didn't change anything :S
any ideas ?
Offline
up...
Offline
Pages: 1