You are not logged in.
Hi all.
I've try to install a E220 modem in my Arch Laptop, but i have a problem i can't get a ppp interface.
I've done this:
1.- lsusb
BUS ==> Bus 001 Device 008: ID 12d1:1003 Huawei Technologies Co., Ltd. E220 HSDPA Modem / E230/E270 HSDPA/HSUPA Modem
2.- Install wvdial, usb_modeswitch and ppp
pacman -S wvdial usb_modeswitch ppp
3.- Configure wvdial
[Dialer Jazztel]
Modem Type = Analog Modem
Phone = *99#
ISDN = 0
Baud = 460800
Modem = /dev/ttyUSB0
Init1 = AT+CPIN=MyPIN
Init2 = ATZ
Init3 = at+cgdcont=1,"ip","jazzinternet"
Stupid Mode = 1
4.- Run wvdial
sudo wdial Jazztel
Wvdial Output:
--> WvDial: Internet dialer version 1.61
--> Cannot get information for serial port.
--> Initializing modem.
--> Sending: AT+CPIN=MyPIN
AT+CPIN=MyPIN
OK
--> Sending: ATZ
ATZ
OK
--> Sending: at+cgdcont=1,"ip","jazzinternet"
at+cgdcont=1,"ip","jazzinternet"
OK
--> Modem initialized.
--> Configuration does not specify a valid login name.
--> Configuration does not specify a valid password.
Modem led its ok (Cyan blinking), but none ppp interface.
Can someone help me?
Thanks and best regards.
Last edited by Pilli (2010-10-01 13:03:30)
Offline
Offline
Hi Karol.
I've read that article and i've used mkwvconf to configure my ISP before postting here, but i thought that user and pasword were not necessaries and i was wrong. I've need set Username and Password to empty string.
My configuration is:
[Dialer Jazztel]
Modem Type = Analog Modem
Phone = *99***1#
ISDN = 0
Baud = 460800
Username = ''
Password = ''
Modem = /dev/ttyUSB0
Init1 = AT+CPIN=MyPIN
Init2 = ATZ
Init3 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
Init4 = at+cgdcont=1,"ip","jazzinternet"
Stupid Mode = 1
Now works.
Thanks and best regards.
Last edited by Pilli (2010-10-03 13:59:37)
Offline