You are not logged in.
So I am writing a 6in4 script for netcfg. The last step in tunnel_up() is to assign the IPv6 address(es) to the newly created tunnel interface...
Should I just add the addresses to tun0? This is the simplest way.
Should I add address[es] to the carrier interface (eth0), and just add $addr/128 to tun0? This lets other LAN users reach this PC using its global IP address[es], which seems like an obvious thing to have, and this is the current behavior.
...what if the LAN is on a different interface than the one used by tunnel? (for example, Internet access on eth0 and LAN on eth1.)
Offline