You are not logged in.
I have a laptop running the intel video driver at 1024x768
I want to connect the laptop to an external monitor via cable. When the monitor is connected I want to change the resolution to 1680x1050.
I wont need to use the laptops screen once this is active.
If anyone could help me setup my
/etc/X11/xorg.conf.d/10-monitor.conf
It would be much appreciated.
Arch Linux since 2006
Python Web Developer + Sys Admin (Gentoo/BSD)
Offline
When you connect the external monitor you can simply run xrandr to set the new resolution.
There's no such thing as a stupid question, but there sure are a lot of inquisitive idiots !
Offline
Thanks, just what I was looking for!
Arch Linux since 2006
Python Web Developer + Sys Admin (Gentoo/BSD)
Offline
I use arandr fronend for this.. its awesome, check it out
Offline
bind the xrandr command you find fits your config to a key combination
Offline