You are not logged in.
I know this is a very newbie question, but I have searched for an answer and all I can find is about how to code the key bindings. I have looked at the Arch Wiki page for OpenBox and at the OpenBox Wiki page on Help:Configuration, among other places.
I am taking my first baby steps to opening a few applications. I added my correct code to ~/.config/openbox/rc.xml, but they did not do anything. Then, I exited X, ran startx, and my new key bindings worked.
Surely there is a way to make the new rc.xml file take effect without stopping and starting X. But I cannot find it. Sorry.
Tim
Last edited by ratcheer (2012-06-12 13:16:00)
Offline
man openbox
A hint: You've changed Openbox's configuration
Sakura:-
Mobo: MSI MAG X570S TORPEDO MAX // Processor: AMD Ryzen 9 5950X @4.9GHz // GFX: AMD Radeon RX 5700 XT // RAM: 32GB (4x 8GB) Corsair DDR4 (@ 3000MHz) // Storage: 1x 3TB HDD, 6x 1TB SSD, 2x 120GB SSD, 1x 275GB M2 SSD
Making lemonade from lemons since 2015.
Offline
One could even say you would like to "reconfigure" it as it were.
Burninate!
Offline
Thanks for the hint, WorMzy. I will follow up on it.
Tim
Offline