You are not logged in.
Pages: 1
Hello everybody, thanks for your time in reading this.
I am currently running kde and nvidia drivers, fully updated. I have a TV screen and my regular monitor; when I'm working I like my monitor as my only output and when I'm loosing time I like my TV screen as my only output. Before, I used to configure both settings in nvidia settings and then used:
$ disper -S && nvidia-settings --config=~/.nvidia-settings-viera-rc --load-config-onlyto activate my TV for example. The TV has a small quirk in which I had to setup "Overscan Compensation" to 100 in order to the image to fit the screen.
After a recent upgrade in both kde and nvidia drivers, two issues arose, first disper stopped working:
$ disper -S
deletion of dangling metamode 50 failed
could not switch to metamode 51: resolution not foundand secondly the Overscan Compensation was removed from nvidia-settings. After reading around in the nvidia changelog and README I figured I had to make a MetaMode that looks someting like this: "DFP-1: 1900x1080 +0+0 { ViewPortOut=1800x980+50+50 }"
How to I add that metamode and how do I change to it via command line?
I passed my whole morning messing with xorg.conf with absolutely no results, I even deleted the whole xorg.conf and noticed it had no effect. So I came to the forums for some enlightenment, thanks again.
Last edited by denn1s (2012-06-29 16:35:14)
--
Running: Arch - x86_64 - KDE
On: Intel i5 - Nvidia 9600
Offline
So, I found one solution messing around by myself, the tip is that in recent updates xorg.conf is barely used and X uses more xrandr. I was able to fix the overscan compensation issue with a setting in my TV, after that it was easy:
xrandr --output DVI-I-3 --off --output DVI-I-2 --mode 1920x1080xrandr --output DVI-I-3 --mode 1920x1080 --output DVI-I-2 --offYou can read the name of your displays and available modes by running "xrandr" without parameters in terminal.
--
Running: Arch - x86_64 - KDE
On: Intel i5 - Nvidia 9600
Offline
Pages: 1