You are not logged in.

#1 2012-06-24 19:22:18

denn1s
Member
From: Guatemala
Registered: 2009-03-10
Posts: 28

[SOLVED] MetaModes

Hello everybody, thanks for your time in reading this.

I am currently running kde and nvidia drivers, fully updated. I have a TV screen and my regular monitor; when I'm working I like my monitor as my only output and when I'm loosing time I like my TV screen as my only output. Before, I used to configure both settings in nvidia settings and then used:

$ disper -S && nvidia-settings --config=~/.nvidia-settings-viera-rc --load-config-only

to activate my TV for example. The TV has a small quirk in which I had to setup "Overscan Compensation" to 100 in order to the image to fit the screen.

After a recent upgrade in both kde and nvidia drivers, two issues arose, first disper stopped working:

$ disper -S
deletion of dangling metamode 50 failed
could not switch to metamode 51: resolution not found

and secondly the Overscan Compensation was removed from nvidia-settings. After reading around in the nvidia changelog and README I figured I had to make a MetaMode that looks someting like this: "DFP-1: 1900x1080 +0+0 { ViewPortOut=1800x980+50+50 }"

How to I add that metamode and how do I change to it via command line?

I passed my whole morning messing with xorg.conf with absolutely no results, I even deleted the whole xorg.conf and noticed it had no effect. So I came to the forums for some enlightenment, thanks again.

Last edited by denn1s (2012-06-29 16:35:14)


--
Running: Arch - x86_64 - KDE
On: Intel i5 - Nvidia 9600

Offline

#2 2012-06-29 16:34:51

denn1s
Member
From: Guatemala
Registered: 2009-03-10
Posts: 28

Re: [SOLVED] MetaModes

So, I found one solution messing around by myself, the tip is that in recent updates xorg.conf is barely used and X uses more xrandr. I was able to fix the overscan compensation issue with a setting in my TV, after that it was easy:

xrandr --output DVI-I-3 --off --output DVI-I-2 --mode 1920x1080
xrandr --output DVI-I-3 --mode 1920x1080 --output DVI-I-2 --off

You can read the name of your displays and available modes by running "xrandr" without parameters in terminal.


--
Running: Arch - x86_64 - KDE
On: Intel i5 - Nvidia 9600

Offline

Board footer

Powered by FluxBB