You are not logged in.

#1 2013-01-09 19:25:33

nbouscal
Member
Registered: 2013-01-09
Posts: 2

Touchpad won't work on Cr-48

I installed Arch on my Cr-48 following the instructions in this thread. I've been able to get past almost all of the problems I ran into using the Wiki, but am getting pretty well stuck at trying to make the touchpad work. Left and right click work, but the cursor doesn't move. The synaptics module isn't showing up in lsmod, and when I looked into it further I found that the module is in /lib/modules/3.6.11-1-ARCH, but uname -r returns 3.4.0. When I try to modprobe the module anyway it returns a fatal module not found error. Additionally, in /proc/bus/input/devices the touchpad only has Handler=event6. I'm very much a newbie when it comes to this kind of stuff, so I have no idea where I should be going from here.

Offline

#2 2013-01-09 21:38:33

Strike0
Member
From: Germany
Registered: 2011-09-05
Posts: 1,277

Re: Touchpad won't work on Cr-48

Welcome to the forum. Not a solution, but another user faces the same problem as you. Maybe you want to follow the thread also and join efforts: https://bbs.archlinux.org/viewtopic.php?id=155207

Offline

#3 2013-01-09 22:41:46

nbouscal
Member
Registered: 2013-01-09
Posts: 2

Re: Touchpad won't work on Cr-48

That is the same problem, thank you for the link! I guess I should have searched the forums a bit more thoroughly than I did. I'll keep an eye on that thread and try to follow up on some of the ideas that have been posted in it.

Offline

Board footer

Powered by FluxBB