You are not logged in.
I'm having issues with networking on a newly installed Arch Linux instance.
Relevanct lspci data
25:00.0 Network controller: Qualcomm Atheros AR9285 Wireless Network Adapter (PCI-Express) (rev 01)
26:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168 PCI Express Gigabit Ethernet controller (rev 06)Network manager output
NetworkManager[2201]: <info> NetworkManager (version 0.9.8.2) is starting...
NetworkManager[2201]: <info> Read config file /etc/NetworkManager/NetworkManager.conf
NetworkManager[2201]: <info> WEXT support is enabled
NetworkManager[2201]: <info> Loaded plugin keyfile: (c) 2007 - 2010 Red Hat, Inc. To report bugs please use the NetworkManager mailing list.
NetworkManager[2201]: keyfile: parsing MagnificentBumrag ...
NetworkManager[2201]: keyfile: read connection 'MagnificentBumrag'
NetworkManager[2201]: <info> monitoring kernel firmware directory '/lib/firmware'.
NetworkManager[2201]: <info> rfkill3: found WiFi radio killswitch (at /sys/devices/pci0000:00/0000:00:1c.3/0000:25:00.0/ieee80211/phy0/rfkill3) (driver ath9k)
NetworkManager[2201]: <info> rfkill1: found WiFi radio killswitch (at /sys/devices/platform/hp-wmi/rfkill/rfkill1) (platform driver hp-wmi)
NetworkManager[2201]: <info> WiFi hardware radio set enabled
NetworkManager[2201]: <info> WiFi enabled by radio killswitch; enabled by state file
NetworkManager[2201]: <info> WWAN enabled by radio killswitch; enabled by state file
NetworkManager[2201]: <info> WiMAX enabled by radio killswitch; enabled by state file
NetworkManager[2201]: <info> Networking is enabled by state file
NetworkManager[2201]: <info> (wlo1): using nl80211 for WiFi device control
NetworkManager[2201]: <info> (wlo1): driver supports Access Point (AP) mode
NetworkManager[2201]: <info> (wlo1): new 802.11 WiFi device (driver: 'ath9k' ifindex: 3)
NetworkManager[2201]: <info> (wlo1): exported as /org/freedesktop/NetworkManager/Devices/0
NetworkManager[2201]: <info> (wlo1): device state change: unmanaged -> unavailable (reason 'managed') [10 20 2]
NetworkManager[2201]: <info> (wlo1): bringing up device.
NetworkManager[2201]: <info> (wlo1): preparing device.
NetworkManager[2201]: <info> (wlo1): deactivating device (reason 'managed') [2]
NetworkManager[2201]: <warn> failed to allocate link cache: (-10) Operation not supported
NetworkManager[2201]: <info> (enp38s0): carrier is OFF
NetworkManager[2201]: <info> (enp38s0): new Ethernet device (driver: 'r8169' ifindex: 2)
NetworkManager[2201]: <info> (enp38s0): exported as /org/freedesktop/NetworkManager/Devices/1
NetworkManager[2201]: <info> (enp38s0): device state change: unmanaged -> unavailable (reason 'managed') [10 20 2]
NetworkManager[2201]: <info> (enp38s0): bringing up device.
NetworkManager[2201]: <info> (enp38s0): preparing device.
NetworkManager[2201]: <info> (enp38s0): deactivating device (reason 'managed') [2]
NetworkManager[2201]: <info> Added default wired connection 'Wired connection 1' for /sys/devices/pci0000:00/0000:00:1c.5/0000:26:00.0/net/enp38s0
NetworkManager[2201]: <warn> /sys/devices/virtual/net/lo: couldn't determine device driver; ignoring...
NetworkManager[2201]: <warn> /sys/devices/virtual/net/lo: couldn't determine device driver; ignoring...
NetworkManager[2201]: <info> (wlo1) supports 4 scan SSIDs
NetworkManager[2201]: <info> (wlo1): supplicant interface state: starting -> ready
NetworkManager[2201]: <info> (wlo1): device state change: unavailable -> disconnected (reason 'supplicant-available') [20 30 42]
NetworkManager[2201]: <warn> Trying to remove a non-existant call id.
NetworkManager[2201]: <info> (wlo1): supplicant interface state: ready -> disconnected
NetworkManager[2201]: <info> (wlo1) supports 4 scan SSIDs
NetworkManager[2201]: <info> (wlo1): supplicant interface state: disconnected -> inactive
NetworkManager[2201]: <info> (enp38s0): carrier now ON (device state 20)
NetworkManager[2201]: <info> (enp38s0): device state change: unavailable -> disconnected (reason 'carrier-changed') [20 30 40]
NetworkManager[2201]: <info> Auto-activating connection 'Wired connection 1'.
NetworkManager[2201]: <info> Activation (enp38s0) starting connection 'Wired connection 1'
NetworkManager[2201]: <info> (enp38s0): device state change: disconnected -> prepare (reason 'none') [30 40 0]
NetworkManager[2201]: <info> Activation (enp38s0) Stage 1 of 5 (Device Prepare) scheduled...
NetworkManager[2201]: <info> Activation (enp38s0) Stage 1 of 5 (Device Prepare) started...
NetworkManager[2201]: <info> Activation (enp38s0) Stage 2 of 5 (Device Configure) scheduled...
NetworkManager[2201]: <info> Activation (enp38s0) Stage 1 of 5 (Device Prepare) complete.
NetworkManager[2201]: <info> Activation (enp38s0) Stage 2 of 5 (Device Configure) starting...
NetworkManager[2201]: <info> (enp38s0): device state change: prepare -> config (reason 'none') [40 50 0]
NetworkManager[2201]: <info> Activation (enp38s0) Stage 2 of 5 (Device Configure) successful.
NetworkManager[2201]: <info> Activation (enp38s0) Stage 3 of 5 (IP Configure Start) scheduled.
NetworkManager[2201]: <info> Activation (enp38s0) Stage 2 of 5 (Device Configure) complete.
NetworkManager[2201]: <info> Activation (enp38s0) Stage 3 of 5 (IP Configure Start) started...
NetworkManager[2201]: <info> (enp38s0): device state change: config -> ip-config (reason 'none') [50 70 0]
NetworkManager[2201]: <info> Activation (enp38s0) Beginning DHCPv4 transaction (timeout in 45 seconds)
dhcpcd[2262]: sending commands to master dhcpcd process
NetworkManager[2201]: <info> dhcpcd started with pid 2262
NetworkManager[2201]: <info> Activation (enp38s0) Beginning IP6 addrconf.
NetworkManager[2201]: <info> Activation (enp38s0) Stage 3 of 5 (IP Configure Start) complete.
NetworkManager[2201]: <info> (enp38s0): DHCPv4 client pid 2262 exited with status 0
NetworkManager[2201]: <info> Activation (enp38s0) Stage 4 of 5 (IPv4 Configure Timeout) scheduled...
NetworkManager[2201]: <info> Activation (enp38s0) Stage 4 of 5 (IPv4 Configure Timeout) started...
NetworkManager[2201]: <info> Activation (enp38s0) Stage 4 of 5 (IPv4 Configure Timeout) complete.
NetworkManager[2201]: <info> Activation (enp38s0) Stage 3 of 5 (IP Configure Start) starting DHCPv6 as requested by IPv6 router...
NetworkManager[2201]: <info> Activation (enp38s0) Beginning DHCPv6 transaction (timeout in 45 seconds)
NetworkManager[2201]: <warn> the dhcpcd backend does not support IPv6.
NetworkManager[2201]: <info> Activation (wlo1) starting connection 'MagnificentBumrag'
NetworkManager[2201]: <info> (wlo1): device state change: disconnected -> prepare (reason 'none') [30 40 0]
NetworkManager[2201]: <info> Activation (wlo1) Stage 1 of 5 (Device Prepare) scheduled...
NetworkManager[2201]: <info> Activation (wlo1) Stage 1 of 5 (Device Prepare) started...
NetworkManager[2201]: <info> Activation (wlo1) Stage 2 of 5 (Device Configure) scheduled...
NetworkManager[2201]: <info> Activation (wlo1) Stage 1 of 5 (Device Prepare) complete.
NetworkManager[2201]: <info> Activation (wlo1) Stage 2 of 5 (Device Configure) starting...
NetworkManager[2201]: <info> (wlo1): device state change: prepare -> config (reason 'none') [40 50 0]
NetworkManager[2201]: <info> Activation (wlo1/wireless): connection 'MagnificentBumrag' requires no security. No secrets needed.
NetworkManager[2201]: <info> Config: added 'ssid' value 'MagnificentBumrag'
NetworkManager[2201]: <info> Config: added 'scan_ssid' value '1'
NetworkManager[2201]: <info> Config: added 'key_mgmt' value 'NONE'
NetworkManager[2201]: <info> Activation (wlo1) Stage 2 of 5 (Device Configure) complete.
NetworkManager[2201]: <info> Config: set interface ap_scan to 1
NetworkManager[2201]: <info> (wlo1): supplicant interface state: inactive -> scanning
NetworkManager[2201]: <info> (wlo1): supplicant interface state: scanning -> authenticating
NetworkManager[2201]: <info> (wlo1): supplicant interface state: authenticating -> associating
NetworkManager[2201]: <info> (wlo1): supplicant interface state: associating -> completed
NetworkManager[2201]: <info> Activation (wlo1/wireless) Stage 2 of 5 (Device Configure) successful. Connected to wireless network 'MagnificentBumrag'.
NetworkManager[2201]: <info> Activation (wlo1) Stage 3 of 5 (IP Configure Start) scheduled.
NetworkManager[2201]: <info> Activation (wlo1) Stage 3 of 5 (IP Configure Start) started...
NetworkManager[2201]: <info> (wlo1): device state change: config -> ip-config (reason 'none') [50 70 0]
NetworkManager[2201]: <info> Activation (wlo1) Beginning DHCPv4 transaction (timeout in 45 seconds)
dhcpcd[2361]: sending commands to master dhcpcd process
NetworkManager[2201]: <info> dhcpcd started with pid 2361
NetworkManager[2201]: <info> Activation (wlo1) Stage 3 of 5 (IP Configure Start) complete.
NetworkManager[2201]: <info> (wlo1): DHCPv4 client pid 2361 exited with status 0
NetworkManager[2201]: <info> Activation (wlo1) Stage 4 of 5 (IPv4 Configure Timeout) scheduled...
NetworkManager[2201]: <info> Activation (wlo1) Stage 4 of 5 (IPv4 Configure Timeout) started...
NetworkManager[2201]: <info> (wlo1): device state change: ip-config -> failed (reason 'ip-config-unavailable') [70 120 5]
NetworkManager[2201]: <warn> Activation (wlo1) failed for connection 'MagnificentBumrag'
NetworkManager[2201]: <info> Activation (wlo1) Stage 4 of 5 (IPv4 Configure Timeout) complete.
NetworkManager[2201]: <info> (wlo1): device state change: failed -> disconnected (reason 'none') [120 30 0]
NetworkManager[2201]: <info> (wlo1): deactivating device (reason 'none') [0]
NetworkManager[2201]: <warn> Connection disconnected (reason -3)
NetworkManager[2201]: <info> (wlo1): supplicant interface state: completed -> disconnected
NetworkManager[2201]: <warn> Connection disconnected (reason -3)I have run modprobe with the driver (ath9k) and it still won't work.
When connected to Wired, the internet works but it keeps saying 'Setting network address' without moving forward. When trying to connect to wireless it says 'Configuring interface' but then goes back to not connected.
Also, if I put Link-Local as the ipv4 method, it will connect successfully but then disconnect again. The (reasion 'ip-config-unavailable') pops up over and over again.
Also, I've tried wpa_supplicant, netctl, and wicd.
Offline