You are not logged in.

#1 2013-11-16 00:22:02

adomas
Member
From: Panevėžys, Lithuania
Registered: 2011-01-05
Posts: 21
Website

Mouse Freeze

Hello,
I just installed a fresh installation of ArchLinux x86_64 on my new computer and now every from 2 to 5 minutes the mouse freezes. I have to reconnect it manually to use it. Mouse is Logitech M100. Here is dmesg:

[   33.074482] usb 3-10.2.2: USB disconnect, device number 6
[   34.413953] usb 3-10.2.2: new low-speed USB device number 8 using xhci_hcd
[   34.432298] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[   34.434796] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input20
[   34.434983] hid-generic 0003:046D:C05A.0005: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[   61.147553] usb 3-10.2.2: USB disconnect, device number 8
[   62.615176] usb 3-10.2.2: new low-speed USB device number 9 using xhci_hcd
[   62.633547] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[   62.636033] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input21
[   62.636217] hid-generic 0003:046D:C05A.0006: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[   74.145665] e1000e 0000:00:19.0: irq 45 for MSI/MSI-X
[   74.248735] e1000e 0000:00:19.0: irq 45 for MSI/MSI-X
[   74.248808] IPv6: ADDRCONF(NETDEV_UP): eno1: link is not ready
[   74.957696] IPv6: ADDRCONF(NETDEV_UP): enp3s0: link is not ready
[   77.334059] igb: enp3s0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
[   77.334431] IPv6: ADDRCONF(NETDEV_CHANGE): enp3s0: link becomes ready
[   89.220517] usb 3-10.2.2: USB disconnect, device number 9
[   90.689570] usb 3-10.2.2: new low-speed USB device number 10 using xhci_hcd
[   90.707740] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[   90.710117] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input22
[   90.710332] hid-generic 0003:046D:C05A.0007: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[   96.278579] nvidia 0000:01:00.0: irq 51 for MSI/MSI-X
[   97.071684] NVRM: Your system is not currently configured to drive a VGA console
[   97.071686] NVRM: on the primary VGA device. The NVIDIA Linux graphics driver
[   97.071687] NVRM: requires the use of a text-mode VGA console. Use of other console
[   97.071688] NVRM: drivers including, but not limited to, vesafb, may result in
[   97.071688] NVRM: corruption and stability problems, and is not supported.
[  143.700304] usb 3-10.2.2: USB disconnect, device number 10
[  144.398155] usb 3-10.2.2: new low-speed USB device number 11 using xhci_hcd
[  144.416346] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[  144.418572] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input23
[  144.418719] hid-generic 0003:046D:C05A.0008: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[  250.352306] usb 3-10.2.2: USB disconnect, device number 11
[  251.307626] usb 3-10.2.2: new low-speed USB device number 12 using xhci_hcd
[  251.325946] usb 3-10.2.2: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[  251.328288] input: Logitech USB Optical Mouse as /devices/pci0000:00/0000:00:14.0/usb3/3-10/3-10.2/3-10.2.2/3-10.2.2:1.0/input/input24
[  251.328530] hid-generic 0003:046D:C05A.0009: input,hidraw2: USB HID v1.11 Mouse [Logitech USB Optical Mouse] on usb-0000:00:14.0-10.2.2/input0
[adomas@localhost ~]$ 

Any ideas how to fix this so I don't need to reconnect the mouse? I think it might be something with USB 3 support...

Offline

#2 2013-11-16 18:09:53

max kaspar
Member
Registered: 2013-04-11
Posts: 40

Re: Mouse Freeze

I had the same problem with the same mouse, and solved it by replacing the mouse (the cable got loose). Check with another mouse.

Last edited by max kaspar (2013-11-16 18:10:23)

Offline

#3 2013-11-21 09:04:30

adomas
Member
From: Panevėžys, Lithuania
Registered: 2011-01-05
Posts: 21
Website

Re: Mouse Freeze

I have dual boot with Windows 8.1 and there everything is OK hmm maybe it's not the mouse problem, but Linux kernel? No?

Offline

#4 2013-11-21 13:12:41

max kaspar
Member
Registered: 2013-04-11
Posts: 40

Re: Mouse Freeze

Well, I dual boot with Windows 7. Again, the same situation, there were mouse lockups in Linux, Windows was working fine, until it completely stopped working. I guess linux is more sensitive smile. Just replace the mouse. it's not that it;s some high-end mouse.

Offline

Board footer

Powered by FluxBB