Arch Linux

ThElitEyeS

Banned

Registered: 2014-03-25

Posts: 129

[SLOVED]reaver 1.4 wash wont show output

[root@USB bahaa]# iwconfig
wlp7s0    IEEE 802.11bgn  ESSID:"START"  
          Mode:Managed  Frequency:2.422 GHz  Access Point: 00:16:E3:EF:47:9C   
          Bit Rate=48 Mb/s   Tx-Power=20 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=61/70  Signal level=-49 dBm  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

lo        no wireless extensions.

enp8s0    no wireless extensions.

wlp0s29u1u3  IEEE 802.11bgn  ESSID:off/any  
          Mode:Managed  Access Point: Not-Associated   Tx-Power=20 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          
[root@USB bahaa]# 

I am using wlp0s29u1u3

[root@USB bahaa]# systemctl stop NetworkManager
[root@USB bahaa]# airmon-ng start wlp0s29u1u3
[root@USB bahaa]# wash -i mon0 -C

Then

Wash v1.4 WiFi Protected Setup Scan Tool
Copyright (c) 2011, Tactical Network Solutions, Craig Heffner <cheffner@tacnetsol.com>

BSSID                  Channel       RSSI       WPS Version       WPS Locked        ESSID
---------------------------------------------------------------------------------------------------------------



[root@USB bahaa]# 

It exits instantly
I tried to create the following directories:
/etc/reaver
/usr/etc/reaver
/usr/local/etc/reaver

but yet nothing works

Last edited by ThElitEyeS (2014-05-05 00:27:46)

ThElitEyeS

Banned

Registered: 2014-03-25

Posts: 129

Re: [SLOVED]reaver 1.4 wash wont show output

Copied wash from blacklinux
seems to be working fine
download link:
https://www.dropbox.com/s/drrt4c0d64p7jqq/wash