You are not logged in.

#1 2003-12-17 22:29:00



Has anyone used the atmelwlandriver with pcmcia-cs?  I only started using Arch today so maybe I'm doing something silly.  My card's a Belkin F5D6020v2, and I followed basically the same steps which worked under Gentoo.

I installed pcmcia-cs from abs as the normal "pacman -S" didn't seem to install the modules correctly.  I then manually installed the atmewlandriver from and added "eth1" to rc.conf.  But restarting pcmcia and network doesn't work - the modules, including pcmf502rd from the atmel package, load fine, but dhcpcd refuses to find the IP address.  I don't really know where to go from here.. Any help will be greatly appreciated...


Board footer

Powered by FluxBB