You are not logged in.

#1 2006-08-14 18:26:17

Registered: 2003-10-24
Posts: 5,000

Connect new Panasonic TZ1 camera

The camera is listed in lsusb but not the same ID as is listed in autodetect within digikam.

Digikam reports it cannot connect with the camera ID it autodetected!!

I suspect the TZ1 has additional requirements for the interface because it has audfio capability with still picture capture.  This mode has to be established within digikam when it is connected and such may not be the case.

Is there any way to correct this  condition of no connection to an identified interface in digikam?

Prediction...This year will be a very odd year!
Hard work does not kill people but why risk it: Charlie Mccarthy
A man is not complete until he is married..then..he is finished.
When ALL is lost, what can be found? Even bytes get lonely for a little bit!     X-ray confirms Iam spineless!


Board footer

Powered by FluxBB