Arch Linux

BHatGuy

Member

From: Germany

Registered: 2019-08-08

Posts: 9

USB stick not recognized

Since a few weeks ago my USB stick isn't recognized by my system correctly. If I plug it in it shows up as for example /dev/sdb but after about a minute it disappeares again. Sometimes all USB devices get disabled until next reboot. However I can use other USB sticks just fine, but this issue occurs on both my laptop and my desktop PC.

dmesg gives me some errors, but I can't find any solution.

[   73.250389] usb 2-2: new SuperSpeed Gen 1 USB device number 2 using xhci_hcd
[   73.272301] usb 2-2: New USB device found, idVendor=090c, idProduct=3267, bcdDevice=11.00
[   73.272306] usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[   73.272311] usb 2-2: Product: Flash Disk
[   73.272314] usb 2-2: Manufacturer: USB
[   73.299818] usb-storage 2-2:1.0: USB Mass Storage device detected
[   73.300032] scsi host3: usb-storage 2-2:1.0
[   73.300180] usbcore: registered new interface driver usb-storage
[   73.305464] usbcore: registered new interface driver uas
[   74.430788] scsi 3:0:0:0: Direct-Access     USB      Flash Disk       1100 PQ: 0 ANSI: 6
[   74.432397] sd 3:0:0:0: [sdb] 125829120 512-byte logical blocks: (64.4 GB/60.0 GiB)
[   74.433159] sd 3:0:0:0: [sdb] Write Protect is off
[   74.433165] sd 3:0:0:0: [sdb] Mode Sense: 43 00 00 00
[   74.433984] sd 3:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[   74.464840]  sdb: sdb1
[   74.468486] sd 3:0:0:0: [sdb] Attached SCSI removable disk
[   75.983811] audit: type=1101 audit(1575460452.318:117): pid=1586 uid=1000 auid=1000 ses=2 msg='op=PAM:accounting grantors=pam_unix,pam_permit,pam_time acct="malte" exe="/usr/bin/sudo" hostname=? addr=? terminal=/dev/pts/0 res=success'
[   75.984410] audit: type=1110 audit(1575460452.318:118): pid=1586 uid=0 auid=1000 ses=2 msg='op=PAM:setcred grantors=pam_unix,pam_permit,pam_env acct="root" exe="/usr/bin/sudo" hostname=? addr=? terminal=/dev/pts/0 res=success'
[   75.993373] audit: type=1105 audit(1575460452.328:119): pid=1586 uid=0 auid=1000 ses=2 msg='op=PAM:session_open grantors=pam_limits,pam_unix,pam_permit acct="root" exe="/usr/bin/sudo" hostname=? addr=? terminal=/dev/pts/0 res=success'
[  110.644802] usb 2-2: Disable of device-initiated U1 failed.
[  115.764546] usb 2-2: Disable of device-initiated U2 failed.
[  121.097544] xhci_hcd 0000:00:14.0: Timeout while waiting for setup device command
[  126.430549] xhci_hcd 0000:00:14.0: Timeout while waiting for setup device command
[  126.637072] usb 2-2: device not accepting address 2, error -62
[  126.857284] usb 2-2: Device not responding to setup address.
[  127.067374] usb 2-2: Device not responding to setup address.
[  127.273688] usb 2-2: device not accepting address 2, error -71
[  127.493832] usb 2-2: Device not responding to setup address.
[  127.703895] usb 2-2: Device not responding to setup address.
[  127.910346] usb 2-2: device not accepting address 2, error -71
[  128.130613] usb 2-2: Device not responding to setup address.
[  128.340531] usb 2-2: Device not responding to setup address.
[  128.546969] usb 2-2: device not accepting address 2, error -71
[  128.600435] sd 3:0:0:0: [sdb] tag#0 FAILED Result: hostbyte=DID_TIME_OUT driverbyte=DRIVER_OK
[  128.600447] sd 3:0:0:0: [sdb] tag#0 CDB: Read(10) 28 00 07 7f ff fc 00 00 01 00
[  128.600456] blk_update_request: I/O error, dev sdb, sector 125829116 op 0x0:(READ) flags 0x80700 phys_seg 1 prio class 0
[  128.600459] usb 2-2: USB disconnect, device number 2
[  128.613799] blk_update_request: I/O error, dev sdb, sector 125829112 op 0x0:(READ) flags 0x0 phys_seg 1 prio class 0
[  128.613812] Buffer I/O error on dev sdb, logical block 15728639, async page read
[  128.850573] usb 2-2: Device not responding to setup address.
[  129.060364] usb 2-2: Device not responding to setup address.
[  129.266929] usb 2-2: device not accepting address 3, error -71
[  129.487121] usb 2-2: Device not responding to setup address.
[  129.697111] usb 2-2: Device not responding to setup address.
[  129.903552] usb 2-2: device not accepting address 4, error -71
[  129.930424] usb usb2-port2: attempt power cycle
[  130.850363] usb 2-2: Device not responding to setup address.
[  131.060340] usb 2-2: Device not responding to setup address.
[  131.266866] usb 2-2: device not accepting address 5, error -71
[  131.486876] usb 2-2: Device not responding to setup address.
[  131.696826] usb 2-2: Device not responding to setup address.
[  131.903473] usb 2-2: device not accepting address 6, error -71
[  131.930236] usb usb2-port2: unable to enumerate USB device
[  132.170287] usb 2-2: Device not responding to setup address.
[  132.380357] usb 2-2: Device not responding to setup address.
[  132.586855] usb 2-2: device not accepting address 7, error -71
[  132.810396] usb 2-2: Device not responding to setup address.
[  133.020384] usb 2-2: Device not responding to setup address.
[  133.226879] usb 2-2: device not accepting address 8, error -71
[  133.253638] usb usb2-port2: attempt power cycle
[  134.173869] usb 2-2: Device not responding to setup address.
[  134.383872] usb 2-2: Device not responding to setup address.
[  134.590243] usb 2-2: device not accepting address 9, error -71
[  134.810371] usb 2-2: Device not responding to setup address.
[  135.020370] usb 2-2: Device not responding to setup address.
[  135.226970] usb 2-2: device not accepting address 10, error -71
[  135.253758] usb usb2-port2: unable to enumerate USB device