You are not logged in.
I have a Dell Latitude and I would like to have wifi on it.
When I run the arch installer (aug. 2020) I have no problem getting wifi, I can install arch over wifi. My adapter is name wlan0 when I run the installer.
After install, I have no wlan0 adapter, instead I have this wwp0s20u1u6i6 adapter. I'm able to set this up or down with
ip link set wwp0s29u1u6i6 up
or
ip link set wwp0s29u1u6i6 down
When I then try to list my adapters with
nmcli device
I only get
DEVICE TYPE STATE CONNECTION
eno1 ethernet connected Wired connection 1
lo loopback unmanaged --
My wwp0s29u1u6i6 device is not listed.
Now, I'm quite sure that my proper adapter name should have been wlan0 instead of wwp0s29u1u6i6, since that is what I had during installation. But I don't know if there's a missing driver or something else that's not in place.
I am quite new to arch, so I haven't been able to figure this one out yet. Can anyone please help me in the right direction?
Best regards
Jon
Offline