You are not logged in.

#1 2007-06-21 12:51:37

edpl
Member
Registered: 2007-04-25
Posts: 8

Connection at system start

Hi,
since system upgrade (about 2 weeks ago) i have problem with estabilish internet connection at system start.
To connect i have to:
ifconfig ra0 10.14.1.4 broadcast 10.14.1.255 netmask 255.255.255.0
iwconfig ra0 essid WiNet-AP14 mode 2 channel 7

but, even before it iwconfig and ifconfig looks ok:

iwconfig:

ra0       RT2400PCI  ESSID:"WiNet-AP14"
          Mode:Managed  Channel=7  Bit Rate:11 Mb/s   
          RTS thr:off   Fragment thr:off
          Encryption key:off

ifconfig:

ra0       Link encap:Ethernet  HWaddr 00:0C:76:CA:85:7C
          inet addr:10.14.1.4  Bcast:10.14.1.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:76ff:feca:857c/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:17 Base address:0x4000


any ideas?
/etc/rc.conf and /etc/conf.d/wireless seems to be fine.
i'm using card with rt2400 chip. drivers from http://rt2x00.serialmonkey.com/wiki/ind … =Main_Page (i tried with beta and daily)

sorry for my english.

Last edited by edpl (2007-06-21 12:57:34)

Offline

#2 2007-06-22 13:17:46

edpl
Member
Registered: 2007-04-25
Posts: 8

Re: Connection at system start

in /var/log.everything.log
i found line:
Jun 22 13:57:45 skrzynia ra0: no IPv6 routers present

and in messages.log:
Jun 22 13:59:50 skrzynia ***RT2400***: !!! MLME busy, NIC will be reset!!!

Last edited by edpl (2007-06-22 13:22:24)

Offline

Board footer

Powered by FluxBB