You are not logged in.
Hi all,
I've got quite a strange problem: my network card only works during setup. It's an 8139 based card and works fine during the initial setup but I cannot get the system to recognise it afterwards.
I've tried various combinations of 8139too and 8139cp modules but to no avail.
Is there a way of running a similar setup program when Arch has been installed? I'm stuck for ideas and want to get that box up and running.
Any help would be greatly received.
UPDATE:
Previously, setup (0.8) detected my network card. I just downloaded "duke" and that fails to even find it during setup. I've been wondering if it was something to do with my PCI controller .. 'lshwd' shows it as "AMD-751 PCI to PCI bridge" but the module comes up as "unknown".
Any ideas?
Last edited by bishnabob (2007-06-25 12:20:17)
Offline
Check dmesg for a clue to eth0.....itmay have changed to eth1?
Prediction...This year will be a very odd year!
Hard work does not kill people but why risk it: Charlie Mccarthy
A man is not complete until he is married..then..he is finished.
When ALL is lost, what can be found? Even bytes get lonely for a little bit! X-ray confirms Iam spineless!
Offline
This is what seems relevant from dmesg ..
8139too Fast Ethernet driver 0.9.28
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 10
PCI: setting IRQ 10 as level-triggered
ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link [LNKC] -> GSI 10 (level, low) -> IRQ 10
PCI: Unable to reserve I/O region #1:100@de00 for device 0000:00:0a.0
Trying to free nonexistent resource <000000000000de00-000000000000deff>
Trying to free nonexistent resource <00000000efffff00-00000000efffffff>
8139too: probe of 0000:00:0a.0 failed with error -16The full copy is available at: http://www.aimphotography.co.uk/temp/dmesg.txt
Thanks for any help I can get.
Offline