You are not logged in.
hi, i can't connect my laptop to my wifi network... i have a usb wireless card (3com 3CRWE254G72_V1.0.9.3) i did the driver instalation with ndiswrapper because the driver it's for XP...
Ok, the card it's working, i can see my wifi net, but i can't connect it...
This is the problem :
[root@jag /]# /etc/rc.d/network restart
:: Stopping Network [DONE]
:: Starting Network [BUSY]
Error, wlan0: ioctl SIOCSIFMTU: Invalid argument
[DONE]
??????? i dont now why...
Some info about my system...
[root@jag etc]# iwconfig wlan0
wlan0 IEEE 802.11b ESSID:"JavieRG"
Mode:Managed Frequency:2.462 GHz Access Point: 00:09:5B:D8:F3:A6
Bit Rate=11 Mb/s
RTS thr=2347 B Fragment thr=2346 B
Encryption key:off
Power Management:off
Link Quality:89/100 Signal level:-39 dBm Noise level:-96 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@jag etc]# iwlist wlan0 scan
wlan0 Scan completed :
Cell 01 - Address: 00:09:5B:D8:F3:A6
ESSID:"JavieRG"
Protocol:IEEE 802.11b
Mode:Managed
Frequency:2.462 GHz (Channel 11)
Quality:85/100 Signal level:-41 dBm Noise level:-96 dBm
Encryption key:off
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s
Extra:bcn_int=100
Extra:atim=1
my /etc/rc.conf:
lo="lo 127.0.0.1"
eth0="dhcp"
wlan0="dhcp"
INTERFACES=(lo eth0 wlan0)
my /etc/conf.d/wireless:
wlan_wlan0="wlan0 essid JavieRG"
WLAN_INTERFACES=(wlan0)
The problem again
[root@jag /]# /etc/rc.d/network restart
:: Stopping Network [DONE]
:: Starting Network [BUSY]
Error, wlan0: ioctl SIOCSIFMTU: Invalid argument
[DONE]
thanks for as
Offline
OK, this is funny, but i dont now what's up here...
i change the rc.conf from:
lo="lo 127.0.0.1"
eth0="dhcp"
wlan0="dhcp"
INTERFACES=(lo eth0 wlan0)
to:
my /etc/rc.conf:
lo="lo 127.0.0.1"
eth0="dhcp"
INTERFACES=(lo eth0)
The eth0 may the pcmcia LAN card
and now, the wirelles woks...
how is this possible?
Offline