You are not logged in.

#1 2004-05-01 15:08:38

sear
Member
Registered: 2004-04-24
Posts: 42

x.org config file

hi there

where is the x.org configuration file?

is it the same like xfree86 ? i dont think so....

at boot it just says "loading de_CH keymap failed" but i entered de_CH-latin1 (in the xfree86 config file) and the scrollwheel of my logitech mouse doesnt work, but it is set up the same way as bevor x update....

there has to be a second config file for x.org, not?

thanks
sear

Offline

#2 2004-05-01 17:45:10

scottro
Member
From: NYC
Registered: 2002-10-11
Posts: 454
Website

Re: x.org config file

I haven't played with xorg in a bit, but it was just like XF86Config--it's there in /etc/X11 IIRC

Offline

#3 2004-05-02 00:40:10

IceRAM
Member
From: Bucharest, Romania
Registered: 2004-03-04
Posts: 772
Website

Re: x.org config file

Check this thread (there's a solution in there):
http://bbs.archlinux.org/viewtopic.php?t=4221

Offline

#4 2004-05-03 14:31:27

soffcore
Member
Registered: 2004-04-27
Posts: 42

Re: x.org config file

it can read your old XF86Config file, but if you need to make a new one run

xorgconfig

smile

or was it

xorgconf

Well its one of the two. I have a logitech USB mouse and the wheel works just as it did in xfree86.

Offline

#5 2004-05-03 19:03:51

IceRAM
Member
From: Bucharest, Romania
Registered: 2004-03-04
Posts: 772
Website

Re: x.org config file

Oh, of course it works with the XFree config file.

I was saying that the KBD solution can be found there. I think the mappings don't work no matter what config file you use.

Regarding the mouse, I also copied the config from XFree config file to the Xorg config file, even I could have used the same file.

Offline

Board footer

Powered by FluxBB