You are not logged in.
Pages: 1
I only know modprobe ipv6, and don't know what to do next.
I want to connect to ipv6 ftp site.
My ip looks like 192.168.0.101,and connect to the internect through a router 192.168.0.254
how to configure the router,dns,etc...
And i found nothing on wiki.
Last edited by ora (2008-04-26 01:28:47)
Offline
Offline
It's not what i want. gw6c is only a gateway or proxy.
It's ok to surf the ipv6 webpages with it. BUT connect to ipv6 ftp site need massive data transfer.
I want to configure my card,dns,router, not a gateway or proxy.
Offline
If you found nothing in our wiki, that just means that nobody has had the time/interest to write it up yet. Search elsewhere, and I'm sure you will find some howtos or tutorials - after all, your request is not distro-dependant.
When you have found the information that you need, you might like to add it to the wiki yourself.
Offline
carlocci wrote:It's not what i want. gw6c is only a gateway or proxy.
It's ok to surf the ipv6 webpages with it. BUT connect to ipv6 ftp site need massive data transfer.
I want to configure my card,dns,router, not a gateway or proxy.
I misinterpreted your post.
May I know what ISP you are using? I find it surprising it has already deployed ipv6: are you a tester?
Offline
My ip looks like 192.168.0.101,and connect to the internect through a router 192.168.0.254
Those are both IPv4 addresses reserved for use on LANs - ergo: they are useless to us. Is your WAN address IPv4 too, or IPv6?
Got Leenucks? :: Arch: Power in simplicity :: Get Counted! Registered Linux User #392717 :: Blog thingy
Offline
Pages: 1