I´m a newbie on ArchLinux.
Now, I would connect to my Canon Powershot A70 camera.
USB ist running, the usb-storage and sd_mod moduls are load.
I type "less /proc/bus/usb/devices" and found the camera.
T: Bus=03 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 4 Spd=12 MxCh= 0
D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=32 #Cfgs= 1
P: Vendor=04a9 ProdID=3073 Rev= 0.01
S: Manufacturer=Canon Inc.
S: Product=Canon Digital Camera
C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr=100mA
I: If#= 0 Alt= 0 #EPs= 3 Cls=06(still) Sub=01 Prot=01 Driver=(none)
E: Ad=81(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=83(I) Atr=03(Int.) MxPS= 8 Ivl=96ms
The mount piont "/mnt/camera" exists, but I can´t mount the cam.
[root@arbeit root]# mount -t vfat /dev/sda1 /mnt/camera
mount: Gerätedatei /dev/sda1 existiert nicht
/dev/stderr /dev/stdin /dev/stdout
controlC0 pcmC0D0c pcmC0D0p pcmC0D1c pcmC0D2p timer
What can I do? I would not use gphoto2, or simular programms.
Can you post the output of dmesg after you plug in your camera?
yes, there is now a "usb 3-1: new full speed USB device using address 6" message or "usb 3-1: USB disconnect, address 6" when, i shot down the camera.
and what does it say when you plug it in?
usb 3-1: new full speed USB device using address 6
I have a A60, I use gphoto2 and digikam and works perfect, I only had to edit fstab to allow normal users use the usb, I followed more a less this howto: http://www.phil.uni-sb.de/~nkuttler/os/powershot/
I have an A40 and the only way I can get pictures off the camera is using gphoto2. You can't just mount my camera as a usb storage device.
I have discovered that all of mans unhappiness derives from only one source, not being able to sit quietly in a room
- Blaise Pascal