You are not logged in.

#1 2008-10-12 19:39:36

deconstrained
Member
Registered: 2008-03-31
Posts: 49

Syntax for WEP-128 in /etc/network.d/ ?

Hello,

I've succeeded in getting my wireless network controller working in Arch, only I have to enable it manually since I get "could not associate wlan0" on bootup. It's because I hadn't written a configuration file for wlan0 in /etc/network.d so I'm doing that now, *but* I've run into the following confusion:

I've seen the syntax for plain old WEP encryption in /etc/network.d/examples, but is it different for WEP 128 ASCII, which is what I'm using on my network? I ask because the syntax for /etc/rc.conf is different between the two types of encryption, and I've googled it to no avail. I was wondering if anyone here had the answer. Thank you.

Offline

Board footer

Powered by FluxBB