You are not logged in.
[greg@box ~]$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11bg ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Tx-Power=0 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
I am trying to get my wireless working but I am quite out of my comfort zone doing this. Is my wireless card recognized here? And if so how do I go about in actually using it? I haven't installed any wireless manager yet. I wanted to confirm everything was okay first.
Greg
Last edited by gregoryma (2008-12-16 18:59:58)
Offline
wlan0 is your wireless card.
Try this guide
http://wiki.archlinux.org/index.php/Wir … Management
Offline
Thanks, the link confirmed it is working.
Greg
Offline
And this page too. Although, you probably would have found from the other:
Offline