Arch Linux

BeRReGoN

Member

Registered: 2008-03-28

Posts: 35

Problem when updating dhcpcd file

My internet is working fine except when i update the dhcpcd file i can't access a lot of server or site. Example, i use the gatech server with pacman but after the dhcpcd update i can't.

I can visit the archlinux website but not his wiki or forum...

Any clue?

i just use dhcp in my rc.conf for my eth0

here my lspci:

04:07.0 Ethernet controller: Broadcom Corporation BCM4401-B0 100Base-TX (rev 02)
04:09.0 Communication controller: Conexant HSF 56k Data/Fax Modem

and my ifconfig -a:

eth0      Link encap:Ethernet  HWaddr 00:1A:A0:1F:56:EC  
          inet addr:24.212.59.90  Bcast:255.255.255.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:576  Metric:1
          RX packets:28258 errors:18 dropped:0 overruns:0 frame:18
          TX packets:6011 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:5033084 (4.7 Mb)  TX bytes:708820 (692.2 Kb)
          Interrupt:19 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:284 errors:0 dropped:0 overruns:0 frame:0
          TX packets:284 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:17836 (17.4 Kb)  TX bytes:17836 (17.4 Kb)

Last edited by BeRReGoN (2009-01-02 16:16:05)

BeRReGoN

Member

Registered: 2008-03-28

Posts: 35

Re: Problem when updating dhcpcd file

When i use dhclient i got the same problem too. I'm out of clue right now...