You are not logged in.

#1 2009-03-22 01:19:18

Stythys
Member
From: SF Bay Area
Registered: 2008-05-18
Posts: 878
Website

ndiswrapper

tryin' to get ndiswrapper working....when I run ndiswrapper -l it lists the device present and all, but iwconfig is still blank. Yes, I've morprobed and everything. never seen this before. any ideas?


[home page] -- [code / configs]

"Once you go Arch, you must remain there for life or else Allan will track you down and break you."
-- Bregol

Offline

#2 2009-03-22 12:36:19

R00KIE
Forum Fellow
From: Between a computer and a chair
Registered: 2008-09-14
Posts: 4,734

Re: ndiswrapper

What does 'ifconfig -a' say? If the card is listed there most probably you forgot to bring the card up before scanning.


R00KIE
Tm90aGluZyB0byBzZWUgaGVyZSwgbW92ZSBhbG9uZy4K

Offline

#3 2009-03-22 19:20:18

Stythys
Member
From: SF Bay Area
Registered: 2008-05-18
Posts: 878
Website

Re: ndiswrapper

ah sry I found out what the problem was...tryin' to use a 32-bit driver on a 64-bit system =P


[home page] -- [code / configs]

"Once you go Arch, you must remain there for life or else Allan will track you down and break you."
-- Bregol

Offline

Board footer

Powered by FluxBB