You are not logged in.
I was following the wiki but I get following error message ..
:: rangalonet up [BUSY] - Authentication/association failed
[FAIL]
I have tried manually with wpa_suppliant and the connection works, the ssid and password are correct.
Any suggestions ?
[EDIT:]
I am using wireless-wpa prifle from the examples under /etc/network.d/examples. Is it correct ?
[PS:]
I am using netcfg-2.2.1-1
Last edited by rangalo (2009-12-13 10:30:54)
Offline
This is now fixed.
I think the reason it was not workin was that I had the network cable connected, so may be there was a conflict. Now I have setup the profiles to connect to the wlan at boot time.
regards,
Hardik
Offline
I think you should use wireless-wpa-config from the examples! Have you put NETWORKS=(your-net-profile) in /etc/rc.conf?
Edit: Too late.
Last edited by Anton (2009-12-13 10:32:36)
Offline
That is available only in new in netcfg 2.5, may be its in testing. I have an older version as mentioned earlier.
Offline