You are not logged in.

#1 2010-02-02 22:35:29

Ashren
Member
From: Denmark
Registered: 2007-06-13
Posts: 1,229
Website

[Solved]Vbox 3.1.2 - Bridged networking stopped working on Arch guest

After upgrading Virtual Box to 3.1.2 (both ose and puel versions apply here) bridged networking stopped working on an Arch guest which I use as a test server.

While writing this post I solved the problem. What I did was to enable NAT on the first adapter and Bridging on the second. After booting into to the guest I did the following;

# ifconfig eth1 up
# dhcpcd eth1

I shutdown the guest and removed the NAT adapter so only the bridged one remained, booted it and voilá for some mysterious and unfathomable reason bridging now works again.

yikes

Offline

Board footer

Powered by FluxBB