You are not logged in.
Pages: 1
Topic closed
I am trying to start dhcpd so that I can do a PXE boot of my old laptop.
Followed the instructions on the PXE wiki page, but they get vague about dhcpd setup.
Do I need to add ipv6 options to dhcpd.conf?
Why am I getting "no ipv6 routers found"? I am using a new modem/router from Bell so I would think it is ipv6 compliant.
Last night tried to apply a patch to dhcp source so that it only uses ipv4 but no luck, I think the patch is outdated.
Offline
Try with dhclient instead. dhcpcd can be temperamental depending on the card.
Offline
my problem is with dhcpd the server not dhcpcd the client
Offline
Please don't cross post. I'll close this one because I misunderstood the question.
Offline
Pages: 1
Topic closed