You are not logged in.
- Topics: Active | Unanswered
#1 2010-05-12 23:57:33
- gowireless
- Member
- Registered: 2010-05-12
- Posts: 20
Installed Wlan card Firmware, but it connect to the network with it
I installed The firmware for my linksys wmp54g wlan card with b43-fwcutter, but the system wont connect to the network on startup, is that normal? if so how do i activate it and have it load on startup?:(
Offline
#2 2010-05-13 00:01:18
- gowireless
- Member
- Registered: 2010-05-12
- Posts: 20
Re: Installed Wlan card Firmware, but it connect to the network with it
i just looked it up and it says to use wireless-tools, which i know i installed when i installed linux, how do i access those tools?
Offline
#3 2010-05-13 00:03:46
- tomk
- Forum Fellow
- From: Ireland
- Registered: 2004-07-21
- Posts: 9,839
Re: Installed Wlan card Firmware, but it connect to the network with it
As I suggested in another thread, read the documentation - in this case, the wiki's Wireless Setup page.
Offline
#4 2010-05-13 00:07:55
- schen
- Member
- Registered: 2009-06-06
- Posts: 468
Re: Installed Wlan card Firmware, but it connect to the network with it
It is normal not to connect on startup. You have to do it yourself. Either use wireless-tools like tomk said or install something like wicd or networkmanager.
Offline