You are not logged in.
I installed The firmware for my linksys wmp54g wlan card with b43-fwcutter, but the system wont connect to the network on startup, is that normal? if so how do i activate it and have it load on startup?:(
Offline
i just looked it up and it says to use wireless-tools, which i know i installed when i installed linux, how do i access those tools?
Offline
As I suggested in another thread, read the documentation - in this case, the wiki's Wireless Setup page.
Offline
It is normal not to connect on startup. You have to do it yourself. Either use wireless-tools like tomk said or install something like wicd or networkmanager.
Offline