You are not logged in.
Hi, all.
Just ironing-out the last couple of bits of my installation, and I can't get my Epson DX-7400 colour printer to appear in Cups.
I've installed Cups, some Foomatic stuff that was mentioned in the wiki, I've got Cups in my daemons in rc.conf and I've checked the cabling. I've also tried blacklisting and then not-blacklisting the usblp module in /etc/modprobe.d/modprobe.conf.
Anyone got any ideas where i'm going wriong? I've had it working under Arch before and all other distros that I've tried.
Thanks,
Chris.
Last edited by chris_debian (2012-06-06 16:18:16)
Offline
check your pacman logs for something like this.
[2012-06-04 10:00] upgraded net-snmp (5.7.1-2 -> 5.7.1-3)
[2012-06-04 10:00] > Please remove your printer in cups, then add it
[2012-06-04 10:00] > back and reconfigure it to make it work again!
[2012-06-04 10:00] upgraded hplip (3.12.4-1 -> 3.12.4-4)There's no such thing as a stupid question, but there sure are a lot of inquisitive idiots !
Offline
Hi, Inxsible.
Thanks for your reply and apologies for my late one. There are three log files under /var/log/cups, but only one has any entries. The entries in the 'access log' are all the same and don't appear to be too helpful. Here is an excerpt:
localhost - - [05/Jun/2012:17:10:03 +0100] "POST / HTTP/1.1" 401 91 CUPS-Get-Devices successful-ok
localhost - root [05/Jun/2012:17:10:03 +0100] "POST / HTTP/1.1" 200 1253 CUPS-Get-Devices -
localhost - root [05/Jun/2012:17:10:03 +0100] "POST /admin/ HTTP/1.1" 200 2886 - -
localhost - - [05/Jun/2012:17:13:47 +0100] "POST /admin/ HTTP/1.1" 200 60 - -
localhost - - [05/Jun/2012:17:13:47 +0100] "POST / HTTP/1.1" 401 91 CUPS-Get-Devices successful-ok
localhost - - [05/Jun/2012:17:13:47 +0100] "POST /admin/ HTTP/1.1" 401 60 - -
localhost - - [05/Jun/2012:17:13:47 +0100] "POST /admin/ HTTP/1.1" 200 60 - -
localhost - root [05/Jun/2012:17:13:56 +0100] "POST /admin/ HTTP/1.1" 200 60 - -
localhost - - [05/Jun/2012:17:13:56 +0100] "POST / HTTP/1.1" 401 91 CUPS-Get-Devices successful-okSorry!
Thanks,
Chris.
Offline
I can see the printer!!
I followed the wiki here:
https://wiki.archlinux.org/index.php/CU … CUPS_1.4.x
and it suddently appeared after a re-boot.
In modprobe.conf, I haven't got anything blacklisted:
#blacklist usblp
I just need to find the correct built-in driver now!
Thanks,
Chris.
Offline
Wow, must have been tired when I did the Arch install! The drivers are much easier to find when you install Gutenprint, as suggested!!
Test page printed, all looking good.
Cheers,
Chris.
Offline