You are not logged in.
Pages: 1
Hi I'm trying to setup openvpn on my RasPi.
I need to set up VLAN's (so I tag frames in and out of the single eth port)
I've been following VLAN - ArchWiki but to no success.
Every-time i try to add I get:
RTNETLINK answers: Operation not supported
By running:
ip link add link eth0 name eth0.10 type vlan id 10
I can only assume the module is not installed/compiled/avaliable?
Any suggestions? modprobe 8021q returns nothing
Cheers,
Chris
Offline
Any suggestions? modprobe 8021q returns nothing
Does `lsmod` confirm that the module 8021q is loaded?
Isn't RaspPi ARM based? You're using Arch Linux ARM?
Are you familiar with our Forum Rules, and How To Ask Questions The Smart Way?
BlueHackers // fscanary // resticctl
Offline
chrisjenx wrote:Any suggestions? modprobe 8021q returns nothing
Does `lsmod` confirm that the module 8021q is loaded?
Isn't RaspPi ARM based? You're using Arch Linux ARM?
lsmod:
Module Size Used by
ipv6 221660 10
So no its not loaded... humm.
Yeah RasPi is ARM, I'm using the RasPi build from here: Arch Linux Rasp
So next stupid question, how do i enable/build the VLAN module, I'll happily follow a tut if there is one?
Offline
So next stupid question, how do i enable/build the VLAN module, I'll happily follow a tut if there is one?
You're more likely to get better answers by asking on the ARM forums; many people here (including myself) have no experience with the ARM port.
In theory, if 8021q isn't built-in to the kernel (check /proc/config.gz) then you should be be able to compile your own kernel using ABS
On a stock arch -lts kernel, 8021q is a module:
$ zgrep 8021Q /proc/config.gz
CONFIG_VLAN_8021Q=m
Are you familiar with our Forum Rules, and How To Ask Questions The Smart Way?
BlueHackers // fscanary // resticctl
Offline
fukawi2 is correct: this belongs on the ARM forums... There is a Pi board there
http://archlinuxarm.org/forum/
Offline
Apologies I should of checked, I thought archlinux was intrinsically arm. My mistake
Cheers all!
Offline
Pages: 1