You are not logged in.

#1 2012-08-03 09:44:44

adriftatsea
Member
From: earth
Registered: 2012-08-03
Posts: 6

[SOLVED] Problems displaying Unicode characters within URXVT...

EDIT - Fixed somehow after a reboot.  Guess it required more than an 'xrdb ~/.Xdefaults'...



Howdy.

In short, I cannot display certain Unicode characters within URXVT.  They are replaced by an 'a' with a caret atop it (see image below)

7703346430_e4b897f91a.jpg

.Xresources

Xft.antialias:    rgba
Xft.dpi:    96
Xft.rgba:    rgb
Xft.hinting:    true
Xft.hintstyle:    hintslight
URxvt.xftAntialias: true
URxvt.font: xft:DejaVu Sans Mono:pixelsize=20:antialias=true:hinting=true, xft:inconsolata:pixelsize=20:antialias=true:hinting=true
URxvt.boldFont: xft:DejaVu Sans Mono:pixelsize=20:antialias=true:hinting=true, xft:inconsolata:pixelsize=20:antialias=true:hinting=true
URxvt.italicFont: xft:DejaVu Sans Mono:pixelsize=20:antialias=true:hinting=true, xft:inconsolata:pixelsize=20:antialias=true:hinting=true
URxvt.bolditalicFont: xft:DejaVu Sans Mono:pixelsize=20:antialias=true:hinting=true, xft:inconsolata:pixelsize=20:antialias=true:hinting=true

Fonts:

community/ttf-inconsolata
extra/ttf-dejavu

So as you can see above, I've included Inconsolata as my fallback font.  No dice.
- cleared font cache w/: fc-cache -fv
- fc-match Monospace reads: DejaVuSansMono.ttf: "DejaVu Sans Mono " "Book"
- tried usig 'urxvt -fn "xft: Terminus'
- same result when using 'xterm'
- 'locale -a' -> POSIX, en_US.utf8

Any ideas?  Thanks

Last edited by adriftatsea (2012-12-25 02:12:29)

Offline

#2 2012-08-03 12:15:54

karol
Archivist
Registered: 2009-05-06
Posts: 25,440

Re: [SOLVED] Problems displaying Unicode characters within URXVT...

If the issues is fixed, please remember to mark the thread as solved.
https://bbs.archlinux.org/viewtopic.php?id=130309

Offline

#3 2012-08-07 10:30:42

schalox
Member
From: Finland
Registered: 2011-05-10
Posts: 21

Re: [SOLVED] Problems displaying Unicode characters within URXVT...

I'm having the same problem while using systemd. If I reinstall initscripts, the problem goes away. Specifically, putting locale.sh in /etc/profile.d/ fixes the problem. Here's my /etc/locale.conf:

LANG=en_GB.UTF-8
LC_COLLATE=C
LC_MONETARY=fi_FI.UTF-8
LC_NUMERIC=fi_FI.UTF-8

Does someone know how to fix this?

Edit: Stupid me... should've read the systemd wiki-page more carefully. Solution was to to install systemd-sysvcompat.

Last edited by schalox (2012-08-07 10:46:57)

Offline

Board footer

Powered by FluxBB