You are not logged in.

#1 2012-10-04 03:49:45

wolfcore
Member
From: California
Registered: 2012-03-06
Posts: 137

"Failed to enable AA" error

 ~ 33/38 % dmesg | grep 'error'                    
[    1.214795] ata1.00: failed to enable AA (error_mask=0x1)
[    1.221195] ata1.00: failed to enable AA (error_mask=0x1)

I am getting this error every time I boot.
I saw https://bbs.archlinux.org/viewtopic.php?id=138993 and obviously the error is the same, but I have been researching and can't  find what is causing this problem.

Offline

#2 2012-10-04 08:44:18

moetunes
Member
From: A comfortable couch
Registered: 2010-10-09
Posts: 1,024

Re: "Failed to enable AA" error

I found this post which gave some boot options that centos use to fix that apparently. The thread ends there so it will be up to you to test them and see. There are a few reports on that error tho.


You're just jealous because the voices only talk to me.

Offline

#3 2012-10-05 02:31:37

wolfcore
Member
From: California
Registered: 2012-03-06
Posts: 137

Re: "Failed to enable AA" error

moetunes wrote:

I found this post which gave some boot options that centos use to fix that apparently. The thread ends there so it will be up to you to test them and see. There are a few reports on that error tho.

I seem to recall using the boot options "ide0=noprobe ide1=noprobe" on
CentOS 4 and CentOS5 to prevent the SATA controller from being used as a
legacy (lower performance) IDE controller.

I tried adding those options in the APPEND section of syslinux.cfg, but that did not work. By 'boot options' does it mean bootloader options? Or is this something else?

Offline

#4 2012-10-05 09:22:39

moetunes
Member
From: A comfortable couch
Registered: 2010-10-09
Posts: 1,024

Re: "Failed to enable AA" error

They are kernel boot options, in grub they would go on the kernel line. I don't use syslinux but looking at the wiki for it you added the options in the right place. I guess they aren't going to work.


You're just jealous because the voices only talk to me.

Offline

Board footer

Powered by FluxBB