You are not logged in.

#1 2012-10-11 13:32:02

MajinJoko
Member
Registered: 2007-08-15
Posts: 66

new 64bit installation based on existing x86 system

Hello there!

I'm using a x86 Arch, and my hard disk is partitioned as follow:
sda1 root
sda7 home
sda6 oth

Where "oth" is a partition empy.
I would like to "clone" my actual system to a new 64bit one.
So, I can boot arch-dual-dvd in 64bit mode, install the new arch in sda6 then use it as new root.

I am writing this to ask you whether is possible to "clone" my system as much as possible: installing the same packages, keeping the configuration files ( /etc/ ? ), don't touch the home and re-use in the new system..

Any hint will be REALLY appreciated!
M

Offline

#2 2012-10-11 14:19:28

nomorewindows
Member
Registered: 2010-04-03
Posts: 3,015

Re: new 64bit installation based on existing x86 system

There's no any easier way that what you have already described however I tend to daisy chain my x86_64 and i686 so that I can chroot the i686 under x86_64 and then I have access to 32-bit chroot, (not that I use it all that much).   But then you can also make a slight change to your i686 kernel and make it available (with some other installed services), a PXE bootable image for some other device you have laying around.


I may have to CONSOLE you about your usage of ridiculously easy graphical interfaces...
Look ma, no mouse.

Offline

#3 2012-10-11 15:07:10

Pres
Member
Registered: 2011-09-12
Posts: 423

Re: new 64bit installation based on existing x86 system

Offline

Board footer

Powered by FluxBB