You are not logged in.
Hi:
I'm confronting problems with my printer.
I've installed hplip and hplip-plugin packages from AUR. I've installed my printer. The status I see in hp-toolbox (HP Device Manager) is correct, the printer is online. And I send a test-page and the software says the job has been printed correctly, and the printer do nothing.
I've managed to make the printer print, by doing this:
1. After the pc has boot. I open hp-firmware and click on [Download Firmware]. The application closes normally.
2. I open the console and execute: "sudo rmmod usblp"
And after this two steps the printer prints normally.
Is there anyway of doing this not on every boot ?
Carpe diem, quam minimum credula postero
Offline
Are you sure your system is up to date?
The latest hplip package (3.13.5-2) should fix a problem with firmware loading.
Offline
Are you sure your system is up to date?
The latest hplip package (3.13.5-2) should fix a problem with firmware loading.
No, I'll update my system and I'll be back then.
Carpe diem, quam minimum credula postero
Offline
Are you sure your system is up to date?
The latest hplip package (3.13.5-2) should fix a problem with firmware loading.
No, I'll update my system and I'll be back then.
Carpe diem, quam minimum credula postero
Offline
Are you sure your system is up to date?
The latest hplip package (3.13.5-2) should fix a problem with firmware loading.
I've just updated. Nothing yet. I still have to click [Download firmware] everytime my pc boots to be able to print.
Aynone ?
Carpe diem, quam minimum credula postero
Offline