You are not logged in.

#1 2013-05-20 14:10:57

erick.red
Member
From: Miami, FL, USA
Registered: 2007-06-16
Posts: 41
Website

HP Laserjet P1006 not working properly

Hi:

I'm confronting problems with my printer.

I've installed hplip and hplip-plugin packages from AUR. I've installed my printer. The status I see in hp-toolbox (HP Device Manager) is correct, the printer is online. And I send a test-page and the software says the job has been printed correctly, and the printer do nothing.

I've managed to make the printer print, by doing this:
1. After the pc has boot. I open hp-firmware and click on [Download Firmware]. The application closes normally.
2. I open the console and execute: "sudo rmmod usblp"

And after this two steps the printer prints normally.

Is there anyway of doing this not on every boot ?


Carpe diem, quam minimum credula postero

Offline

#2 2013-05-20 14:58:25

rtoijala
Member
Registered: 2011-09-11
Posts: 29

Re: HP Laserjet P1006 not working properly

Are you sure your system is up to date?
The latest hplip package (3.13.5-2) should fix a problem with firmware loading.

Offline

#3 2013-05-20 20:27:49

erick.red
Member
From: Miami, FL, USA
Registered: 2007-06-16
Posts: 41
Website

Re: HP Laserjet P1006 not working properly

rtoijala wrote:

Are you sure your system is up to date?
The latest hplip package (3.13.5-2) should fix a problem with firmware loading.

No, I'll update my system and I'll be back then.


Carpe diem, quam minimum credula postero

Offline

#4 2013-05-20 20:43:28

erick.red
Member
From: Miami, FL, USA
Registered: 2007-06-16
Posts: 41
Website

Re: HP Laserjet P1006 not working properly

rtoijala wrote:

Are you sure your system is up to date?
The latest hplip package (3.13.5-2) should fix a problem with firmware loading.

No, I'll update my system and I'll be back then.


Carpe diem, quam minimum credula postero

Offline

#5 2013-05-23 19:45:50

erick.red
Member
From: Miami, FL, USA
Registered: 2007-06-16
Posts: 41
Website

Re: HP Laserjet P1006 not working properly

rtoijala wrote:

Are you sure your system is up to date?
The latest hplip package (3.13.5-2) should fix a problem with firmware loading.

I've just updated. Nothing yet. I still have to click [Download firmware] everytime my pc boots to be able to print.

Aynone ?


Carpe diem, quam minimum credula postero

Offline

Board footer

Powered by FluxBB