Arch Linux

Known

Member

Registered: 2012-08-23

Posts: 63

Wireless Access Failed

Hi everyone
I run into a problem in archiso (installation process)
I can't connect to my wireless router.
Here is what it says:
P.S 1: Wired LAN works very well over PPPoE and answers to ping request.
P.S 2: BIOS set to EFI no Secure Boot on.
P.S 3: Wireless works great in Ubuntu Live.

# systemctl status netctl@wlp2s0\x2dMyRouter.service
netctl@wlp2s0x2dMyRouter.service - Networking for netctl profile wlp2s0x2dMyRouter
   Loaded: loaded (/usr/lib/systemd/system/netctl@.service; static)
   Active: inactive (dead)
    Docs: man:netctl.profile(5)

And

# joarnalctl -xn
-- Logs begin at Thu 2013-07-25 06:05:31 UTC end at Thu 2013-07-25 06:07:42 UTC. --
Jul 25 06:07:41 archiso kernel: cfg80211:  (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
Jul 25 06:07:41 archiso kernel: cfg80211:  (2402000 KHz - 2472000 KHz @ 40000 Khz), (300 mBi, 2000 mBm)
Jul 25 06:07:41 archiso kernel: cfg80211:  (2457000 KHz - 2482000 KHz @ 20000 Khz), (300 mBi, 2000 mBm)
Jul 25 06:07:41 archiso kernel: cfg80211:  (2474000 KHz - 2494000 KHz @ 20000 Khz), (300 mBi, 2000 mBm)
Jul 25 06:07:41 archiso kernel: cfg80211:  (5170000 KHz - 5250000 KHz @ 40000 Khz), (300 mBi, 2000 mBm)
Jul 25 06:07:41 archiso kernel: cfg80211:  (5735000 KHz - 5835000 KHz @ 40000 Khz), (300 mBi, 2000 mBm)
Jul 25 06:07:42 archiso network[752]: Failed to bring the network up for profile 'wlp2s0-MyRouter'
Jul 25 06:07:42 archiso systemd[1]: netctl@wlp2s0\x2dMyRouter.service: main process exited, status=1/FAILURE
Jul 25 06:07:42 archiso systemd[1]: Failed to start Networking for netctl profile wlp2s0-MyRouter.
-- Subject: Unit netctl@wlp2s0\x2dMyRouter.service has failed
-- Defined-by: systemd
-- Support: http://lists.freedesktop.org/mailman/li … temd-devel
-- Documentation: http://www.freedesktop.org/wiki/Softwar … e9d022f03d
--
-- Until netctl@wlp2s0\x2dMyRouter.service has failed.
--
-- The result is failed.
Jul 25 06:07:42 archiso systemd[1]: Until netctl@wlp2s0\x2dMyRouter.service entered failed state.

What do I have to do?

Last edited by Known (2013-07-30 11:36:25)