You are not logged in.
I've been using a dual monitor setup using the nouveau drivers for a while. This works fine.
After switching to the proprietary nvidia drivers one of my monitors (DVI-I-0) remains off.
$ xranrd
Screen 0: minimum 8 x 8, current 1440 x 900, maximum 8192 x 8192
DVI-I-0 connected primary (normal left inverted right x axis y axis)
1280x1024 60.02 + 75.02
1024x768 75.03 70.07 60.00
800x600 75.00 72.19 60.32 56.25
640x480 75.00 72.81 59.94
VGA-0 connected 1440x900+0+0 (normal left inverted right x axis y axis) 408mm x 255mm
1440x900 59.89*+ 74.98
1280x1024 76.00 75.02 70.00 60.02
1280x720 60.00
1152x864 75.00
1024x768 75.03 70.07 60.00
800x600 75.00 72.19 60.32 56.25
640x480 75.00 72.81 59.94
DVI-I-1 disconnected (normal left inverted right x axis y axis)
HDMI-0 disconnected (normal left inverted right x axis y axis)
This is how I normally enable the setup:
xrandr --output DVI-I-0 --right-of VGA-0
I'm at a loss about what could be wrong. Can anybody provide some hints?
Thanks!
Last edited by Righard (2014-07-13 16:41:37)
Offline
Can you enable it through nvidia-settings?
Offline
Offline
Hmm, after juggling the DVI connector the monitor suddenly started working. The cable must be damaged. Strange that it did work with nouveau.
Thanks anyway
Last edited by Righard (2014-07-13 16:33:45)
Offline