You are not logged in.

#1 2014-10-30 19:34:18

oxygen_wobble
Member
Registered: 2012-05-20
Posts: 131

force one screen to two monitors (for presentations)

Hi everybody,

so, i usually use an additional screen for my laptop, with two individual screens ...

But, for presentations, i'd like to have the same screen on both monitors ... is there a way to force this on the fly ?

If i start x with two monitors attached, i get the usual multiscreen setup.

if i start with a single monitor (the internal LCD) and attach the external one AFTER starting x, sometimes it shows the same screen,
but today, i held a presentation, and it didn't work (the external monitor just stayed blank), so i had to turn my back on the audience way to often ...

Furthermore, i'm not using a desktop environment, just x and awesome ...

Regards,
n

Offline

#2 2014-10-30 19:39:22

runical
Member
From: The Netherlands
Registered: 2012-03-03
Posts: 896

Re: force one screen to two monitors (for presentations)

You can use xrandr to change the layout (presuming awesome is able to deal with that). If you want to save the configurations, I can recommend xrandr-mgr in the AUR.

If you use nvidia, there is also a graphical tool to set this up (does not work well with xrandr).

Last edited by runical (2014-10-30 19:40:20)

Offline

#3 2014-10-30 19:44:32

oxygen_wobble
Member
Registered: 2012-05-20
Posts: 131

Re: force one screen to two monitors (for presentations)

Well, i know xrandr, but when i run xrandr --auto, will it do the trick ?

There are lots of options to place the screens apart from each other, but not the other way round, so it seems ...

Offline

#4 2014-10-30 20:04:55

olive
Member
From: Belgium
Registered: 2008-06-22
Posts: 1,490

Re: force one screen to two monitors (for presentations)

oxygen_wobble wrote:

Well, i know xrandr, but when i run xrandr --auto, will it do the trick ?

There are lots of options to place the screens apart from each other, but not the other way round, so it seems ...

I thinlk something like:

xrandr --output VGA1 --auto --output VGA2 --auto --same-as VGA1

Now if the two monitors does not have the same default resolution you might need to replace --auto by --mode xxxx for some mode supported by the two monitors.

Last edited by olive (2014-10-30 20:17:54)

Offline

#5 2014-10-30 20:14:48

runical
Member
From: The Netherlands
Registered: 2012-03-03
Posts: 896

Re: force one screen to two monitors (for presentations)

You can also install arandr. It gives a GUI. You should be able to set that up correctly.

Offline

Board footer

Powered by FluxBB