You are not logged in.
Hi everybody,
so, i usually use an additional screen for my laptop, with two individual screens ...
But, for presentations, i'd like to have the same screen on both monitors ... is there a way to force this on the fly ?
If i start x with two monitors attached, i get the usual multiscreen setup.
if i start with a single monitor (the internal LCD) and attach the external one AFTER starting x, sometimes it shows the same screen,
but today, i held a presentation, and it didn't work (the external monitor just stayed blank), so i had to turn my back on the audience way to often ...
Furthermore, i'm not using a desktop environment, just x and awesome ...
Regards,
n
Offline
You can use xrandr to change the layout (presuming awesome is able to deal with that). If you want to save the configurations, I can recommend xrandr-mgr in the AUR.
If you use nvidia, there is also a graphical tool to set this up (does not work well with xrandr).
Last edited by runical (2014-10-30 19:40:20)
Offline
Well, i know xrandr, but when i run xrandr --auto, will it do the trick ?
There are lots of options to place the screens apart from each other, but not the other way round, so it seems ...
Offline
Well, i know xrandr, but when i run xrandr --auto, will it do the trick ?
There are lots of options to place the screens apart from each other, but not the other way round, so it seems ...
I thinlk something like:
xrandr --output VGA1 --auto --output VGA2 --auto --same-as VGA1Now if the two monitors does not have the same default resolution you might need to replace --auto by --mode xxxx for some mode supported by the two monitors.
Last edited by olive (2014-10-30 20:17:54)
Offline
You can also install arandr. It gives a GUI. You should be able to set that up correctly.
Offline